General Plastics - Plastic Fittings for Heating and Air Conditioning -


Home	Products	Installation & Repairs	Engineering Reports	Distributors	Related Articles	Contact Us	Links

Installation Requirements

En Español or English Page <1 2 3> Next Back | Click to Print This Page | Click to View / Print All Pages

Untitled Document

Manufacturer's Required Adhesives
Approved equals may be used per manufacturer instructions

For Black Max® to PVC:

For PVC & Plenums:

For All Fittings:

IPS Weld-On 600

Surebond 190
For Saddle Boots
and L-Bar Hangers

IPS Weld-On 719 PVC

IPS Weld-On P-70 Primer
Clear or Purple

Average Initial Set Schedule
For WELD-ON PVC/CPVC Solvent Cements**

Temperature Range	Pipe Sizes 4" to 8"	Pipe Sizes 10" to 15"	Pipe Sizes 15"+
60° - 100°F	30 minutes	2 hours	4 hours
40° - 60°F	2 hours	8 hours	16 hours
0° - 40°F	12 hours	24 hours	48 hours

Note: Initial set schedule is the necessary time to allow before the joint can be carefully handled. In damp or humid weather allow 50% more set time.

** These figures are estimates based on our laboratory tests; extended set and cure times are required for chemical applications. Due to the many variables in the field, these figures should be used as a general guide only.

English Page <1 2 3> Next Back | Click to Print This Page

General Plastics, Inc. 3500 North Harrison Shawnee, Oklahoma 74804 888-275-3171 sales@general-plastics.com